Pre-Safe Seat Belt - Left - DTCS
PRE-SAFE SEAT BELT - LEFT - DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC C1101 | TCS5 message timeout |
| DTC C1102 | ESP2 message timeout |
| DTC C1103 | SAS1 message timeout |
| DTC C1104 | EMS2 message timeout |
| DTC C1105 | TCU1 message timeout |
| DTC C1106 | CLU2 message timeout |
| DTC C1107 | TCS1 message timeout |
| DTC C1109 | LDWS1 message timeout |
| DTC C110A | ACU1 message timeout |
| DTC C110B | SCC3 message timeout |
| DTC C120B | Signal Accelerator position Sensor CAN not valid |
| DTC C120C | Signal Seat_belt_Driver not valid |
| DTC C120D | Signal Seat_belt_Passenger not valid |
| DTC C120F | Message Count or Checksum not correct |
| DTC C1210 | LDWS System State Not valid |
| DTC C1211 | Signal Passenger Buckled Input State not valid |
| DTC C1212 | Signal Driver Buckled Input State not valid |
| DTC C1213 | Seat_belt_Driver (0x690) and Driver Buckled Input State (0x5A) not plausible |
| DTC C1214 | Seat_belt_Passenger (0x690) and Passenger Buckled Input State (0x5A) not plausible |
| DTC C1220 | Signal WHEEL_FL or WHEEL_FR or WHEEL_RL or WHEEL_RR not Valid |
| DTC C1230 | Signal Yaw Rate or Acceleration AX or Acceleration AY or Brake pressure State not valid |
| DTC C1240 | Signal SAS_Angle not Valid or Signal SAS Msg Count or Checksum not Correct |
| DTC C1310 | Last run was broken (Retraction) |
| DTC C1320 | Data from EEPROM not Valid or Hardware Defects |
| DTC C1404 | CAN Bus Off |
| DTC C1410 | Undervoltage Detected |
| DTC C1420 | Overvoltage Detected |
| DTC C1430 | Overtemperature Detected |
| DTC C2003 | Maximum retractions exceeded (PSB) |