FixVault
Home › Hyundai › 2016 › Santa Fe Sport 2.0T, AWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 2.0L › Boost Pressure Sensor (BPS) › Repair Procedures › Removal

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the boost pressure sensor connector (A).
  3. Remove the installation bolts (B), and then remove the sensor from the surge tank.
    Fig 1: Identifying Boost Pressure Sensor Connector Installation Bolts
    G10582752Courtesy of HYUNDAI MOTOR AMERICA
About FixVault