Repair Procedures: Installation

1. Using a gasket scraper, remove all the old sealant material from the gasket surfaces.
2. Before assembling the oil pan, liquid sealant Loctite 5900H, Threebond 1217H or equivalent should be applied on oil pan. The part must be assembled within 5 minutes after sealant was applied.

   Bead Width:  2.5 mm (0.1 in.)

   Fig 1: Oil Pan Liquid Sealant Application Area

   Courtesy of HYUNDAI MOTOR AMERICA
   CAUTION:

   • When applying sealant gasket, sealant must not be protruded into the inside of oil pan.
   • To prevent leakage of oil, apply sealant gasket on the inner threads of the bolt holes.
3. Install the oil pan (A). Uniformly tighten the bolts in several passes.

   Tightening Torque 

   Bolts B (M9):

   26.5 ~ 30.4 N.m (2.7 ~ 3.1 kgf.m, 19.5 ~ 22.4 lb-ft)

   Bolts C (M6):

   9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

   Fig 2: Oil Pan Mounting Bolts

   Courtesy of HYUNDAI MOTOR AMERICA
   CAUTION: After assembly, wait at least 30 minutes before filling the engine with oil.
   NOTE: Always use a new drain plug gasket.

Tightening Torque: 

19.6 ~ 23.5 N.m (2.0 ~ 2.4 kgf.m, 14.5 ~ 17.4 lb-ft)

Fig 3: A/C Compressor Bracket Bolts

Courtesy of HYUNDAI MOTOR AMERICA

(Refer to: Heating, Ventilation, Air Conditioning - "COMPRESSOR ").