Repair Procedures: Installation

Check that the shift lever is placed in the "N" position.
Lightly tighten the inhibitor switch mounting bolts (B) after installing the inhibitor switch (A).

Fig 1: Tightening Inhibitor Switch Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Lightly tighten the Manual Control Lever Mounting Nut (A) after installing the Manual Control Lever (B).

Fig 2: Tightening Manual Control Lever Mounting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Align the hole (A) in the Manual Control Lever with the "N" position hole (B) of the inhibitor switch and then insert the inhibitor switch guide pin (SST No.:09480-A3800).

Fig 3: Aligning Hole Manual Control Lever With N Position Hole
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the bolts (B) after tightening the nut (A) with the specified torque.
Tightening Torque

(A) 17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)

(B) 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Fig 4: Tightening Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Connect the inhibitor switch connector (A).
Lightly tighten the nut (B) after connected the shift cable (C) in the Manual Control Lever (D).
Push shift cable (C) lightly to "F" direction displayed to eliminate free play of shift cable.
Tighten the nut (B) with the specified torque.
Tightening Torque:

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.8 lb-ft)

Fig 5: Connecting Inhibitor Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor switch guide pin (SST No.:09480-A3800) from the hole.

Fig 6: Removing Inhibitor Switch Guide Pin (09480-A3800) From Hole
Courtesy of HYUNDAI MOTOR AMERICA
Install the battery and battery tray.
(Proceed to Engine Electrical System - "BATTERY ")
Install the TCM.
(Proceed to Dual Clutch Transmission Control System - "TCM ")
Install the air cleaner and air duct.
(Proceed to Engine Mechanical System - "AIR CLEANER 1.6L ")
CAUTION:
- Check that operating surely at each range of the Inhibitor Switch corresponding to each position of shift lever.