FixVault
Home › Hyundai › 2016 › Tucson SE, FWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 2.0L › Camshaft Position Sensor (CMPS) › Repair Procedures › Removal

Repair Procedures: Removal

WARNING:
  • DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.

[Bank 1/Intake] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor.
Fig 1: Locating Camshaft Position Sensor (CMPS) Installation Bolts - Bank 1/Intake
G11643655Courtesy of HYUNDAI MOTOR AMERICA

[Bank 1/Exhaust] 

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (A).
  3. Remove the installation bolt (B), and then remove the sensor.
Fig 2: Locating Camshaft Position Sensor (CMPS) Installation Bolts - Bank 1/Exhaust
G11643656Courtesy of HYUNDAI MOTOR AMERICA
About FixVault