Repair Procedures: Installation

Install the Parking Brake Cable.
Install the parking brake cable (B), and then install the clip (A).

Fig 1: Identifying Parking Brake Cable And Clip
Courtesy of HYUNDAI MOTOR AMERICA
Install the rear tire and wheel.
Install the parking brake lever assembly.

Fig 2: Identifying Parking Brake Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install the parking brake cable.

Fig 3: Identifying Parking Brake Cable With Nut
Courtesy of HYUNDAI MOTOR AMERICA
Apply a coating of the specified grease to each sliding parts (A) of the ratchet plate or the ratchet pawl.
Specified grease:

Multi purpose grease SAE J310, NLGI No. 2

Fig 4: Identifying And Greasing Sliding Part Ratchet Plate / Pawl
Courtesy of HYUNDAI MOTOR AMERICA
Install the parking brake cable adjuster, then adjust the parking brake lever stroke by turning adjusting nut (A).
Parking brake lever stroke:

6 ~ 8 clicks (Pull the lever with 196N (20 kgf, 44 lbf)).

NOTE: After repairing the parking brake shoe, adjust the brake shoe clearance and adjust the parking brake lever stroke. (Refer to: "Parking brake shoe installation").

Fig 5: Parking Brake Lever Stroke Dimension With Torque Specification
Courtesy of HYUNDAI MOTOR AMERICA

Fig 6: Identifying Parking Brake Lever Adjusting Nut
Courtesy of HYUNDAI MOTOR AMERICA
Release the parking brake lever fully, and check that parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully.
Reconnect the connector (A) of parking brake switch.

Fig 7: Identifying Parking Brake Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Inspect the continuity of parking brake switch.

When the brake lever is pulled : continuity

When the brake lever is released : no continuity
Install the floor console.
(Refer to: Body procedure - "Floor console").