FixVault
Home › Hyundai › 2016 › Veloster Base, Standard Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 1.6L GDI › Camshaft Position Sensor (CMPS) › Repair Procedures › Removal › [Bank 1/Exhaust]

[Bank 1/Exhaust]

  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Camshaft Position Sensor Connector (A).
  3. Remove the Hanger and the Protector.
  4. Remove the Installation Bolt (B), and then remove the Sensor.
    Fig 1: Camshaft Position Sensor Connector And Installation Bolt (Bank 1/Exhaust)
    G10607939Courtesy of HYUNDAI MOTOR AMERICA
About FixVault