FixVault
Home › Hyundai › 2016 › Veloster Base, Standard Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 1.6L GDI › Intake Air Temperature Sensor (IATS) › Repair Procedures › Removal

Repair Procedures: Removal

  1. Turn the Ignition Switch OFF and disconnect the Battery Negative (-) Cable.
  2. Disconnect the Manifold Absolute Pressure Sensor Connector (A).
  3. Remove the Installation Bolt (B) and then remove the Sensor from the Surge Tank.
    4. Fig 1: Manifold Absolute Pressure Sensor Connector Installation Bolt
    G00561512Courtesy of HYUNDAI MOTOR AMERICA
About FixVault