FixVault
Home › Hyundai › 2016 › Veloster Base, Standard Trans › Repair and Diagnosis › External Pages › Different car › Section 1 (Disc Brake System) › Brake Switch › Repair Procedures › Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2015 Hyundai Veloster. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fix the Brake Pedal Arm and fully insert the Stop Lamp Switch as hiding contact part.
    Fig 1: Stop Lamp Switch Location
    G10605123Courtesy of HYUNDAI MOTOR AMERICA
  2. After inserting, Turn The Stop Switch (A) 45° clockwise and assemble the Locking Plate (B) by pushing.
    Fig 2: Turning Stop Switch Clockwise
    G10605124Courtesy of HYUNDAI MOTOR AMERICA
  3. Confirm the Gap between Stop Lamp Switch and Bracket.

    Stop Lamp Clearance  : 1.0 ~ 2.0 mm (0.04~ 0.08 in.)

    Fig 3: Gap Between Stop Lamp Switch And Bracket
    G10605125Courtesy of HYUNDAI MOTOR AMERICA
  4. Connect the Stop Lamp Switch Connector.
    NOTE: If the Gap between Stop Lamp Switch and Bracket is not 1.0 ~ 2.0mm (0.04~ 0.08in), perform the above process again.
  5. Install the Lower Crash Pad.

    (Refer to: Body - "CRASH PAD ").

About FixVault