FixVault
Home › Hyundai › 2016 › Veloster Base, Standard Trans › Repair and Diagnosis › Restraints › Air Bag, SRS › Airbag Modules & Clock Spring › Driver Airbag (DAB) Module and Clock Spring › Repair Procedures › Removal

Repair Procedures: Removal

  1. Disconnect the Battery Negative Cable and wait for at least three minutes before beginning work.
  2. Turn the Steering Wheel so that the front wheels can face straight ahead.
  3. Remove the Driver Airbag Module Mounting Bolts (2EA).
    Fig 1: Driver Airbag Module Mounting Bolts
    G10605030Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the Wiring Fixing Clip (C), and then release the Connector Locking Pin to disconnect the Driver Airbag Module Connector (B).
    Fig 2: Wiring Fixing Clip And Driver Airbag Module Connector
    G10605031Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION: The removed Airbag Module should be stored in a clean, dry place with the Pad Cover facing up.
  5. Remove the Steering Wheel and Steering Wheel Column Shroud. (Refer to: Steering System procedure - "STEERING COLUMN AND SHAFT ").
    Fig 3: Steering Wheel And Steering Wheel Column Shroud
    G10605032Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the Clock Spring Connector, then remove the Clock Spring.
    Fig 4: Clock Spring Connector
    G10605033Courtesy of HYUNDAI MOTOR AMERICA
About FixVault