FixVault
Home › Hyundai › 2016 › Veloster Base, Standard Trans › Repair and Diagnosis › Restraints › Air Bag, SRS › Airbag Modules & Clock Spring › Side Airbag (SAB) Module › Repair Procedures › Installation

Repair Procedures: Installation

CAUTION: Be sure to install the harness wires not to be pinched or interfered with other parts.
NOTE:
  • Do not open the lid of the Side Airbag Cover.
  • Make sure that the Airbag Assembly Cover is installed properly. Improper installation may prevent the proper deployment.
  1. Remove the Ignition Key from the vehicle.
  2. Disconnect the Battery Negative Cable and wait for at least three minutes.
  3. Install the new Seat Back Assembly.

    (Refer to: Body procedure - "Seat")

  4. Install the Front Seat Assembly.

    (Refer to: Body procedure - "Seat")

  5. Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.
  6. Reconnect the Battery Negative Cable.
  7. After installing the Side Airbag (SAB), confirm proper system operation:
    1. Turn the Ignition Switch ON; the SRS Indicator Light should be turned on for about six seconds and then go OFF.
About FixVault