Repair Procedures: Installation
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable and wait for at least three minutes before beginning work.
- Install the SRSCM with the SRSCM mounting nuts.
Tightening torque:
6.8 ~ 9.2 N.m (0.69 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)
NOTE: Use new mounting nuts when replacing the SRSCM after a collision. - Connect the SRSCM harness connector.
- Install the rear heating joint duct and floor console. (Refer to "CONSOLE ")
- Reconnect the battery negative cable.
- After installing the SRSCM, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.