Repair Procedures: Replacement

CAUTION:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the center fascia side garnish (A).

Fig 1: Locating Center Fascia Side Garnish
Courtesy of HYUNDAI MOTOR AMERICA
Remove the gear boots (B) and gear knob (A).

Fig 2: Removing Gear Boots And Gear Knob
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the console upper tray complete (A).

Fig 3: Locating Console Upper Tray Complete
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 4: Locating Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Remove the console tray (A).

Fig 5: Locating Console Tray
Courtesy of HYUNDAI MOTOR AMERICA
Remove the console tray met (A).

Fig 6: Locating Console Tray Met
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws and bolts, then remove the console rear complete assembly (A).

Fig 7: Locating Console Rear Complete Assembly With Mounting Screws And Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 8: Locating Connector
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the console extension cover (A).

Fig 9: Locating Console Extension Cover
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the console front complete assembly (A).
NOTE:
- Shift lever to "N" position when remove the console front complete assembly.
Fig 10: Locating Console Front Complete Assembly With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 11: Locating Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damage clips.