Repair Procedures: Replacement

CAUTION:

Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.

Remove the rear seat assembly.
(Refer to Rear Seat - "REAR SEAT ASSEMBLY ")
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
[LH, RH]

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Fig 1: Locating Rear Seat Belt Lower Anchor With Mounting Bolt (LH And RH)
Courtesy of HYUNDAI MOTOR AMERICA

[Center]

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Fig 2: Locating Rear Seat Belt Lower Anchor With Mounting Bolt (Center)
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the rear pillar trim (A).

Fig 3: Locating Rear Pillar Trim
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the luggage partition panel (A).

Fig 4: Locating Luggage Partition Panel With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the rear package tray trim (A).

Fig 5: Locating Rear Package Tray Trim With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damaged clips.