FixVault
Home › Hyundai › 2017 › Azera Base › Repair and Diagnosis › Brakes › Traction Control › Electronic Stability Control (ESC) System Diagnosis › DTC C1260: Steering Angle Sensor Circuit-Signal › Component Inspection

Component Inspection

  1. IG "OFF".
  2. IG "ON".
  3. Connect GDS and select "Diagnostic Trouble Codes (DTCs)" mode.
  4. Using a GDS, Clear DTC.
  5. Using a GDS, Check DTC present.
  6. Are any DTCs present?

    YES 

    • This DTC may be caused by an incorrect calibration of the steering angle sensor. Perform the calibration of the sensor by GDS again.
    • This DTC may be caused by an improper installation of the steering angle sensor. Check it for the installation.
    • If there is no problem about the above items, Substitute with a known-good Steering Angle Sensor and check for proper operation. If problem is corrected, replace Steering Angle Sensor and then go to "Verification of Vehicle Repair " procedure.

      * In a case of replacing the Steering Angle Sensor, operate "Steering Angle Sensor Calibration" by GDS.

    NO 

About FixVault