Repair Procedures: Replacement

CAUTION:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Take care not to scratch the body surface.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the center fascia side garnish (A).

Fig 1: Locating Center Fascia Side Garnish
Courtesy of HYUNDAI MOTOR AMERICA
Remove the gear boots (B) and gear knob (A).

Fig 2: Removing Gear Boots And Gear Knob
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the console upper tray complete (A).

Fig 3: Locating Console Upper Tray Complete
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 4: Locating Connectors
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the cup holder tray (A).

Fig 5: Locating Cup Holder Tray With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the center fascia tray (A).

Fig 6: Locating Center Fascia Tray With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 7: Locating Connectors With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the center fascia panel (A).

Fig 8: Locating Center Fascia Panel With Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 9: Locating Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector are connected in properly.
- Replace any damage clips.