Removal And Installation

Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator Hose ")
Remove the cooling fan assembly.
(Refer to Cooling System - "Cooling Fan ")
Disconnect the ATF cooler hoses.
(Refer to Automatic Transaxle System - "AUTOMATIC TRANSAXLE ")
Disconnect the over flow hose.
(Refer to Cooling System - "Reservoir Tank ")
Remove the radiator mounting brackets (A).
Tightening torque:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Fig 1: Removing Radiator Mounting Brackets
Courtesy of HYUNDAI MOTOR AMERICA
Separate the condenser from the radiator and then pull radiator (A) up and remove it from engine room.

Fig 2: Separating Condenser From Radiator
Courtesy of HYUNDAI MOTOR AMERICA
Installation is in the reverse order of removal.
Fill the radiator with coolant and check for leaks.
NOTE:
- Bleed air from the cooling system.
  - Start engine and let it run until it warms up. (Until the radiator fan operates 3 or 4 times.)
  - Turn off engine and let it cool down. Check the coolant level and add coolant if needed. This will allow trapped air to be removed from the cooling system.
  - Put the radiator cap on tightly, then run engine again and check for leaks.