Repair Procedures: Installation

Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.

Fig 1: Inserting Stop Lamp Switch
Courtesy of HYUNDAI MOTOR AMERICA
After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate by pushing.

Fig 2: Turning Stop Lamp Switch 45° Clockwise
Courtesy of HYUNDAI MOTOR AMERICA
Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance: 1.0 ~ 2.0 mm (0.04~ 0.08 in.)

Fig 3: Checking Stop Lamp Clearance
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- If the gap between stop lamp switch and bracket is not 1.0~2.0 mm (0.04~0.08 in), perform the above process again.
Connect the stop lamp switch connector.
Install the lower crash pad.
(Refer to - "Crash Pad Lower Panel ").