FixVault
Home › Hyundai › 2017 › Elantra Eco › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 1.4L › Electronic Waste Gate Actuator (EWGA) › Repair Procedures › Inspection › [Position Sensor]

[Position Sensor]

  1. Turn ignition switch OFF.
  2. Connect the GDS to the data link connector (DLC).
  3. Check the output voltage at each position of the EWGA position sensor on current data component within the specification.

    Specification:  Refer to "SPECIFICATION "

    Information 

    • When the fault code P2562/3/5 is detected, make adjustment first. Then, check whether the same fault code is detected.
About FixVault