FixVault
Home › Hyundai › 2017 › Elantra GT Automatic Trans › Repair and Diagnosis › Engine Mechanical › Mechanical › Timing System › Timing Chain Cover › Repair Procedures › Removal

Repair Procedures: Removal

Engine removal is not required for this procedure.

NOTE:
  • Use fender covers to avoid damaging painted surfaces.
  • To avoid damage, unplug the wiring connectors carefully while holding the connector portion.

Information 

Mark all wiring and hoses to avoid misconnection.

  1. Disconnect the battery negative terminal.
  2. Remove the RH front wheel.
  3. Remove the RH under cover.
  4. Remove the engine cover.
  5. Remove the cylinder head cover.

    (Refer to "CYLINDER HEAD COVER ")

  6. Drain engine oil and remove the oil pan.

    (Refer to "OIL PAN ")

  7. Remove the engine mounting bracket.

    (Refer to "ENGINE MOUNTING ")

  8. Remove the crankshaft damper pulley.

    (Refer to "CRANKSHAFT DAMPER PULLEY ")

  9. Remove the water pump.

    (Refer to "WATER PUMP ")

  10. Remove the A/C compressor.

    (Refer to "COMPRESSOR ")

  11. Remove the front engine hanger (A).
    Fig 1: Removing Front Engine Hanger
    G12074050Courtesy of HYUNDAI MOTOR AMERICA
  12. Remove the alternator.

    (Refer to "ALTERNATOR ")

  13. Remove the timing chain cover (A) by gently prying the gaps between the cylinder head and cylinder block.
    Fig 2: Removing Timing Chain Cover
    G12074051Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION: Be careful not to damage the contact surfaces of cylinder block, cylinder head and timing chain cover.
About FixVault