Repair Procedures: Installation

Remove the ignition key from the vehicle.
Install in the reverse order of removal.
After installing the SRSCM, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
- SRSCM is sensing the vehicle rollover. SAB, CAB, BPT will be able to expanse if mechanic moves the SRSCM on vehicle during IGN ON state. For this reason, turn the IGN OFF surely and then remove the SRSCM from vehicle.
- If the SRSCM is replaced always perform variant coding. Also, perform the lateral G sensor calibration.
  (Refer to "SRS CONTROL MODULE (SRSCM) ")