Repair Procedures: Removal

Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - "Release Residual Pressure in Fuel Line ")
Turn the ignition switch OFF, and then remove battery (-) cable.
Disconnect the fuel feed tube quick-connector (A).

Fig 1: Fuel Feed Tube Quick-Connector Location
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Open the clamp cover (B) before disconnect the quick connector. (If the clip is applied)

Fig 2: Quick Connector Clamp Cover Open Position
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When removing the quick-connnector with the clip removing tool (A), be careful not to damage the plastic clip (B). If the clip is damaged, fuel line leak can be occurred due to a bad connection.

Fig 3: Locating Plastic Clip And Clip Removing Tool
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the vapor hose (A) which is connected from the PCSV.

Fig 4: Locating PCSV Vapor Hose
Courtesy of HYUNDAI MOTOR AMERICA
Lift the vehicle.
Remove the fuel tank. (Refer to Fuel Delivery System - "Fuel Tank ")
Open the vapor tube and fuel feed line fixing clip (A) to using driver.

Fig 5: Locating Vapor Tube And Fuel Feed Line Fixing Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the fuel line from the bottom of the vehicle.

Fig 6: Vehicle Bottom Fuel Line
Courtesy of HYUNDAI MOTOR AMERICA