FixVault
Home › Hyundai › 2017 › Sonata Plug-In Hybrid › Repair and Diagnosis › External Pages › Different car › Section 249 (Driveshaft Assembly) › TJ Joint › Repair Procedures › Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Hyundai Santa Fe Sport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot.
  2. Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and retainer ring (B) on the driveshaft splines (C).
    Fig 1: Installing Spider Assembly And Retainer Ring On Driveshaft Splines (1 Of 2)
    G12055939Courtesy of HYUNDAI MOTOR AMERICA
    Fig 2: Installing Spider Assembly And Retainer Ring On Driveshaft Splines (2 Of 2)
    G12055940Courtesy of HYUNDAI MOTOR AMERICA
  3. Add specified grease to the joint boot as much as it was wiped away at inspection.
  4. Install the both boot band.
  5. Using the SST (09495-3K000), secure the TJ boot bands.

    Clearance (A)  : 2.0 mm (0.0787 in.) or less

    Fig 3: Securing TJ Boot Bands
    G12055941Courtesy of HYUNDAI MOTOR AMERICA
  6. Install the front driveshaft.

    (Refer to Driveshaft Assembly - "FRONT DRIVESHAFT ")

  7. Check the front alignment.

    (Refer to Suspension System - "FRONT ALIGNMENT ")

About FixVault