Repair Procedures: Removal

Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")
Turn the ignition switch OFF, and then remove battery (-) terminal.
Disconnect the fuel feed tube quick-connector (A).

Fig 1: Disconnecting Fuel Feed Tube Quick-Connector
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Open the clamp cover (B) before disconnect the quick connector. (If the clip is applied)

Fig 2: Opening Clamp Cover
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When removing the quick-connnector with the clip removing tool (A), be careful not to damage the plastic clip (B).
If the clip is damaged, fuel line leak can be occurred due to a bad connection.

Fig 3: Clip Removing Tool
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the vapor hose (A) which is connected from the PCSV.

Fig 4: Disconnecting Vapor Hose From PCSV
Courtesy of HYUNDAI MOTOR AMERICA
Lift the vehicle.
Remove the fuel tank.
(Refer to Fuel Delivery System - "FUEL TANK ")
Remove the vapor tube and low fuel line fixing clip (A) by using a common driver.

Fig 5: Removing Vapor Tube And Low Fuel Line Fixing Clip
Courtesy of HYUNDAI MOTOR AMERICA
Remove the side under cover (A) after loosening the mounting bolts.

Fig 6: Removing Side Under Cover Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Remove the fuel line (A) after loosening the mounting bolts and brackets.

Fig 7: Removing Fuel Line

Courtesy of HYUNDAI MOTOR AMERICA