FixVault
Home › Hyundai › 2017 › Tucson SE, FWD › Repair and Diagnosis › Engine Performance › Fuel Delivery › Fuel Delivery System - 2.0L › Fuel Pump Control Module (FPCM) › Repair Procedures › Removal

Repair Procedures: Removal

  1. Release the residual pressure in fuel line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Remove the rear seat.

    (Refer to Body - "REAR SEAT ASSEMBLY ")

  3. Remove the fuel pump service cover (A).
    Fig 1: Removing Fuel Pump Service Cover
    G12044414Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the fuel pump control module connector (A) and the fuel tank pressure sensor connector (B).
  5. Disconnect the fuel pressure sensor connector (C).
  6. Disconnect the fuel feed tube quick connector (D) and the vapor tube quick-connector (E).
    Fig 2: Disconnecting Fuel Pump Control Module Connector And Fuel Tank Pressure Sensor Connector
    G12044415Courtesy of HYUNDAI MOTOR AMERICA
  7. Remove the locking ring (A) by using the special service tool [No.: 09310-B8100].
Fig 3: Removing Locking Ring
G12044416Courtesy of HYUNDAI MOTOR AMERICA
Fig 4: Locating Fuel Pump Control Module
G12044417Courtesy of HYUNDAI MOTOR AMERICA
About FixVault