Repair Procedures: Disassembly

1. Remove the rear cover (A) after removing nuts.
   Fig 1: Locating Rear Cover

   Courtesy of HYUNDAI MOTOR AMERICA
2. Remove the mounting bolts (A) and the brush holder assembly (B).
   Fig 2: Locating Brush Holder Assembly And Mounting Bolts

   Courtesy of HYUNDAI MOTOR AMERICA
3. Remove the slip ring guide (A) after pulling it.
   Fig 3: Removing Slip Ring Guide

   Courtesy of HYUNDAI MOTOR AMERICA
4. Remove the OAD (Overrunning Alternator Decoupler) cap.
   NOTE:

   • When installing, replace with new OAD cap.
5. Remove the OAD (Overrunning Alternator Decoupler) pulley (A) using the special tool.
   Fig 4: Removing Overrunning Alternator Decoupler Pulley

   Courtesy of HYUNDAI MOTOR AMERICA
6. Un-solder the 3 stator leads (A).
   Fig 5: Locating Stator Leads

   Courtesy of HYUNDAI MOTOR AMERICA
7. Remove the 4 through bolts (A).
   Fig 6: Locating Through Bolts

   Courtesy of HYUNDAI MOTOR AMERICA
8. Disconnect the rotor (A) and brackets (B).

Fig 7: Disconnect Rotor And Brackets

Courtesy of HYUNDAI MOTOR AMERICA