Repair Procedures: Installation

Install the parking brake cable.
Install the parking brake cable (B), and then install the clip (A).

Fig 1: Installing Parking Brake Cable And Clip
Courtesy of HYUNDAI MOTOR AMERICA
Install the rear tire and wheel.
Install the parking brake lever assembly.

Fig 2: Installing Parking Brake Lever Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Install the parking brake cable.

Fig 3: Installing Parking Brake Cable
Courtesy of HYUNDAI MOTOR AMERICA
Apply a coating of the specified grease to each sliding parts (A) of the ratchet plate or the ratchet pawl.
Specified Grease :

Multi purpose grease SAE J310, NLGI No. 2

Fig 4: Locating Ratchet Plate Or Ratchet Pawl Sliding Parts
Courtesy of HYUNDAI MOTOR AMERICA
Install the parking brake cable adjuster, then adjust the parking brake lever stroke by turning adjusting nut (A).
Parking brake lever stroke :

6 ~ 8 clicks (Pull the lever with 196N (20 kgf, 44 lbf))

NOTE: After repairing the parking brake shoe, adjust the brake shoe clearance, and then adjust the parking brake lever stroke.
(Refer to "REAR DISC BRAKE ")

Fig 5: Checking Parking Brake Lever Stroke (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 6: Locating Parking Brake Lever Stroke Adjusting Nut (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Release the parking brake lever fully, and check that parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
Make sure that the parking brakes are fully applied when the parking brake lever is pulled up fully.
Reconnect the connector (A) of parking brake switch.

Fig 7: Locating Parking Brake Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Inspect the continuity of parking brake switch.

When the brake lever is pulled : continuity

When the brake lever is released : no continuity
Install the floor console.
(Refer to "Floor Console ")