FixVault
Home › Hyundai › 2017 › Veloster Base, Standard Trans › Repair and Diagnosis › Drivelines & Axles › Wheel Hubs › Front Axle Assembly › Front Hub/Knuckle › Repair Procedures › Disassembly

Repair Procedures: Disassembly

  1. Remove the snap ring (A).
    Fig 1: Removing Snap Ring
    G12125180Courtesy of HYUNDAI MOTOR AMERICA
  2. Remove the hub assembly from the knuckle assembly.
    1. Install the front knuckle assembly (A) on press.
    2. Lay a suitable adapter (B) upon the hub assembly shaft.
    3. Remove the hub assembly (C) from the knuckle assembly (A) by using press.
    Fig 2: Installing Front Knuckle Assembly On Press
    G12125181Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the hub bearing inner race from the hub assembly.
    1. Install a suitable tool (A) for removing the hub bearing inner race on the hub assembly.
    2. Lay the hub assembly and tool (A) upon a suitable adapter (B).
    3. Lay a suitable adapter (C) upon the hub assembly shaft.
    4. Remove the hub bearing inner race (D) from the hub assembly by using press.
    Fig 3: Removing Hub Bearing Inner Race From Hub Assembly
    G12125182Courtesy of HYUNDAI MOTOR AMERICA
  4. Remove the hub bearing outer race from the knuckle assembly.
    1. Lay the hub assembly (A) upon a suitable adapter (B).
    2. Lay a suitable adapter (C) upon the hub bearing outer race.
    3. Remove the hub bearing outer race from the knuckle assembly by using press.
    Fig 4: Removing Hub Bearing Outer Race From Knuckle Assembly
    G12125183Courtesy of HYUNDAI MOTOR AMERICA
  5. Replace hub bearing with a new one.
About FixVault