FixVault

Check Injector

  1. Ignition "OFF".
  2. Remove Injector.
  3. Check Leakage and clog on Injector.
  4. Measure resistance terminal 1 and 2 of Injector connector (Component side).

    Specification: 

    Coil Resistance (Ω) Temp (°C) Temp (°F)
    1.25 20 68
  5. Is the measured resistance within specifications?

    YES 

    • Go to "Check sensors related to Fuel Trim" as below.

    NO 

    • Substitute with a known-good Injector and check for proper operation. If the problem is corrected, replace Injector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.