Repair Procedures: Installation

Check that the shift lever is placed in the "N" position.
Lightly tighten the inhibitor switch mounting bolts after installing the inhibitor switch (A).

Fig 1: Installing Inhibitor Switch
Courtesy of HYUNDAI MOTOR AMERICA
Lightly tighten the manual control lever mounting nut after installing the manual control lever (B).

Fig 2: Installing Manual Control Lever
Courtesy of HYUNDAI MOTOR AMERICA
Align the hole (B) in the manual control lever with the "N" position hole (A) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).

Fig 3: Inserting SST Inhibitor Switch Guide Pin (09480-A3800)
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the bolts (B) after tightening the nut (A) with the specified torque.
Tightening torque:
1. 17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)
2. 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Fig 4: Locating Bolts And Nut
Courtesy of HYUNDAI MOTOR AMERICA
Lightly tighten the nut (B) after connected the shift cable in the manual control lever.
Push shift cable lightly to "F" direction shown to eliminate free play of shift cable.
Tighten the nut (B) with the specified torque.
Connect the inhibitor switch connector (A).
Tightening torque:

9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.1 lb-ft)

Fig 5: Connecting Inhibitor Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the inhibitor switch guide pin (SST No.: 09480-A3800) from the hole.
Install the battery and battery tray.
(Refer to "BATTERY ")
Install the ECM.
(Refer to "ECM ")
Install the air cleaner assembly and air duct.
(Refer to "AIR CLEANER ")

CAUTION: Check that operating surely at each range of the inhibitor switch corresponding to each position of shift lever.