FixVault
Home › Hyundai › 2018 › Elantra SE, Automatic Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 2.0L › Purge Control Solenoid Valve (PCSV) › Repair Procedures › Removal

Repair Procedures: Removal

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the purge control solenoid valve connector (A).
  3. Disconnect the vapor hoses (B) from the purge control solenoid valve.
  4. Remove the valve (C) from the surge tank after pulling it.
    Fig 1: Locating Purge Control Solenoid Valve, Connector And Vapor Hoses
    G12024934Courtesy of HYUNDAI MOTOR AMERICA
About FixVault