Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Hyundai Elantra. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse the removal procedure.
Use a SST (09581-2T100) when installing the brake caliper assembly.

Fig 1: Installing Brake Caliper Assembly Using Special Service Tool (09581-2T100)
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Connect an air hose (B) to the SST after confirming that the valve of the SST is surely closed.
- Input the SST in the caliper and press the caliper piston while opening the valve of the SST slowly counter clock wise.
- Close the valve (A) of the SST and disconnect the air hose (B); then, open the valve again to get the rest of air out and remove the SST from the caliper.
After installing, bleed the brake system.