Repair Procedures: Installation
WARNING: This page is about a different car, the 2017 Hyundai Santa Fe XL and 2017 Hyundai Santa Fe. However, it is still accessible from the selected car via links, so may be relevant.
- Fix the brake pedal arm and insert fully the stop lamp switch as hiding contact part.
- After inserting, turn the stop switch (A) 45° clockwise, and then assemble locking plate (B) by pushing.
- Confirm the gap between stop lamp switch and bracket.
Stop lamp clearance: 1.0 ~ 2.0 mm (0.04 ~ 0.08 in.)
- Connect the stop lamp switch connector.NOTE: If the gap between stop lamp switch and bracket is not 1.0~2.0mm (0.04~0.08in), perform the above process again.
- Install the lower crash pad.
(Refer to CRASH PAD . )