Repair Procedures: Installation

WARNING: This page is about a different car, the 2017 Hyundai Tucson. However, it is still accessible from the selected car via links, so may be relevant.

Remove the ignition key from the vehicle.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
Install the SRSCM with the SRSCM mounting bolt (A) and nuts (B).
Tightening torque:

7.8 ~ 12.8 N.m (0.8 ~ 1.3 kgf.m, 5.8 ~ 9.4 lb-ft)

Fig 1: Installing SRSCM Mounting Bolt And Nuts
Courtesy of HYUNDAI MOTOR AMERICA
Connect the SRSCM harness connector.
Install the heater ducts and floor console.
(Refer to Body - "FLOOR CONSOLE ASSEMBLY ")
Reconnect the battery negative cable.
After installing the SRSCM, confirm proper system operation:

Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then turns off.