[In The Case Of Installing New ECM]

WARNING: This page is about a different variant/trim than selected.

Perform "Key teaching" procedure with GDS. Refer to TEACHING PROCEDURES
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")

CAUTION:

When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.

Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.

Install in the reverse order of removal.
ECM Installation nut:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)