FixVault
Home › Hyundai › 2019 › Santa Fe SE, AWD › Repair and Diagnosis › Brakes › Traction Control › Electronic Stability Program (Esp) System › ESP Control Module › Repair Procedures › Installation

Repair Procedures: Installation

  1. To install, reverse the removal procedure.
  2. After installation, bleed the brake system.

    (Refer to BRAKE BLEEDING PROCEDURES )

  3. Connect the GDS to the data link connector located underneath the dash panel.
  4. Conduct the Variant coding.
  5. Conduct the Auto Detected Sensor Calibration.
  6. Conduct the Longitudinal G Sensor Calibration.
  7. After replacing the ESP control module execute the "Assembly Check (ECU replacement)" of the additional function to check that the mounting is successful.
About FixVault