Component Inspection

1. Check Battery

1. Turn the ignition switch "ON".
2. Measure voltage between the battery terminal (+) and the battery terminal (-).

   Specification:  Above 11V

3. Is the measured voltage within specification?

YES 

• Replace the ECM with an usable one and check for proper operation. If the problem is corrected, replace the ECM and then go to "VERIFICATION OF VEHICLE REPAIR ".

NO 

• Replace the E-WGA with an usable one and check for proper operation. If the problem is corrected, replace the E-WGA and then go to "VERIFICATION OF VEHICLE REPAIR ".