Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Shift the gear to "N".
- Remove the air cleaner and air duct.
- Remove the air duct (A).
 Courtesy of HYUNDAI MOTOR AMERICA
|
- Disconnect the breather hose (B) and air intake hose (C).
- Remove the air cleaner assembly (D).
Tightening torque:
Hose clamp bolt (C):
2.9 - 4.9 N.m (0.3 - 0.5 kgf.m, 2.1 - 3.6 lb-ft)
Air cleaner assembly bolts (D):
3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)
 Courtesy of HYUNDAI MOTOR AMERICA
|
- Disconnect the position switch connector (A) and then loosening the shift cable mounting nut (B).
 Courtesy of HYUNDAI MOTOR AMERICA
|
- Remove the manual control lever (A) and the washer after removing a nut.
 Courtesy of HYUNDAI MOTOR AMERICA
|
- Remove the position switch (A) after removing the bolts.
 Courtesy of HYUNDAI MOTOR AMERICA
|