FixVault
Home › Hyundai › 2021 › Veloster 2.0, Automatic Trans › Repair and Diagnosis › Engine Performance › Engine Control Systems › Engine Control System - 2.0L › Camshaft Position Sensor (CMPS) › Repair Procedures › Removal › Bank 1/Intake

Bank 1/Intake

  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the camshaft position sensor connector (B) after removing the clip (A).
  3. Remove the installation bolt (C), and then remove the sensor.
G13055546Courtesy of HYUNDAI MOTOR AMERICA
About FixVault