FixVault
Home › Hyundai › 2021 › Veloster 2.0, Automatic Trans › Repair and Diagnosis › Engine Performance › System › Engine Control System Diagnosis - 2.0L (1 Of 3) › DTC P0136-00: O2 Sensor Circuit (Bank 1/Sensor 2) › Component Inspection › Heated O2 Sensor

Heated O2 Sensor

  1. With ignition switch turned "OFF", reconnect the HO2S connector
  2. Warm up the engine to normal operating temperature and let it idle.
  3. Connect GDS and monitor the O2 SNSR VOL.-B1/S2 parameter on the GDS data list.

    Specification:  Above 0.7V at idle

  4. Is sensor data near the specified value?

    YES 

    • Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure

    NO 

    • Check HO2S for contamination, deterioration, or damage. Substitute with a known-good HO2S and check for proper operation. If the problem is corrected, replace HO2S and then go to "VERIFICATION OF VEHICLE REPAIR " procedure
About FixVault