DTC Information And Inspection: DTC Detecting Condition

Troubleshooting	Condition	Possible Cause
Main Action	Rationality check	Poor contact of connector Open or short in O2 Sensor (Up) signal circuit O2 Sensor (Up)
Prerequisite Condition	Dew point end detected Fuel feed back control active Battery voltage is greater than 11V Exhaust Gas temperature is between 280°C and 800°C No injector error No upstream O2 sensor heater error
Threshold Value	Sensor voltage: 0.4 ~ 0.6V
Diagnostic Time	5 sec
MIL	2nd Driving Cycle