Monitor DTC Status

Connect GDS and select the "DTC Analysis" mode.
Click the "DTC Status" to check the DTC information.
Read the "DTC Status" parameter, and Record all DTCs, DTC state and freeze frame data.

Is the DTC active?

YES

Verify the system specifications of the vehicle, and conduct the "S/W Management" → "CLU Variant Coding" in line with the data.

NO

This can occur when the CLU*'s memory was not cleared after the repair.
→ Go to the "VERIFICATION OF REPAIR " procedure.
Inspect an intermittent fault caused by Poor Contact in the CLU*'s connector.

Component	Name_ETM	ETM
Cluster* CLU*	"INSTRUMENT CLUSTER"	SD200-2
ABS	"ABS CONTROL MODULE"
ABS ESP EPB	"ESP CONTROL MODULE"
LKAS	"FRONT VIEW CAMERA"
MDPS	"MDPS UNIT"
SRSCM	"SRS CONTROL MODULE"
SCC	"FRONT RADAR UNIT"	SD957-5
4WD*	"4WD ECM"	SD200-4
TCU	"PCM"
	"TCM"
	"ELECTRONIC CLUTCH MODULE"
TPMS	"BCM"
eCall	"EMERGENCY CALL (E-CALL) MODULE"	SD200-7