Diagnostic Procedure 7
- Unplug 12-pin connector from control unit. Control unit is located in trunk, on right side. Connect jumper wire between connector terminal No. 15 and ground. See WIRING DIAGRAMS . If hazard lights do not flash, go to next step. If hazard lights flash, replace control unit.
- Unplug remote control relay No. 1. Relay is located in trunk, on right side.
- Check for continuity between control unit connector terminal No. 15 and relay connector terminal No. 15. See WIRING DIAGRAMS . If continuity exists, check relay and associated wiring. If continuity does not exist, repair wire between specified connector terminals.