Door Switch Check

Open driver's window. Turn ignition switch to LOCK position and remove key from ignition switch. Close all doors, hood and glass hatch. SECURITY light should turn off. Open any door or back door hatch. SECURITY light should flash in one-second intervals. If SECURITY light operates as described, door switch circuit is okay at this time. If SECURITY light does not operate as described, go to next step.

Ensure ignition switch is in LOCK position. Using a voltmeter, backprobe appropriate terminals at Smart Entrance Control Unit (SECU) harness connector with appropriate door in appropriate position. Refer to the DOOR SWITCH INPUT VOLTAGE TEST table. Also, see Figure . If voltage is not as specified, go to next step. If voltage is as specified, door switch input signals are okay at this time.

DOOR SWITCH INPUT VOLTAGE TEST

Door Position

Terminal No. (Wire Color)

Voltage

Driver's Door

Open

15 (Green/Red)

Closed

15 (Green/Red)

Passenger's Door

Open

35 (Yellow)

Closed

35 (Yellow)

Any Door ⁽¹⁾

Open

16 (Red/Yellow)

Closed

16 (Red/Yellow)

⁽¹⁾	Check voltage at terminal No. 16 at SECU harness connector with each door open and closed, including glass hatch.

Test malfunctioning door switch. See DOOR SWITCH under COMPONENT TESTS. If door switch is defective, replace door switch. If door switch is okay, check door switch ground circuit and signal circuits for opens and/or shorts and repair as necessary. See WIRING DIAGRAMS .