FixVault

DTC Confirmation Test

  1. Turn ignition on. Select DATA MONITOR mode with scan tool. Wait at least 10 seconds.
  2. Press CRUISE switch for at least 10 seconds. Release switch. Wait at least 10 seconds.
  3. Press ACCEL/RES switch for at least 10 seconds. Release switch. Wait at least 10 seconds.
  4. Press COAST/SET switch for at least 10 seconds. Release switch. Wait at least 10 seconds.
  5. Press CANCEL switch for at least 10 seconds. Release switch. Wait at least 10 seconds.
  6. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, system is okay at this time.