2WD Model

Remove propeller shaft from vehicle. Refer to FRONT PROPELLER SHAFT .
Support A/T assembly with a jack.
Remove rear engine mounting member. Tighten rear engine mounting member to the specified torque. Refer to
- For 2001, refer to REMOVAL & INSTALLATION .
- For 2002, refer to REMOVAL AND INSTALLATION .
- For 2003, refer to REMOVAL AND INSTALLATION .
Fig 1: Removing Rear Engine Mounting Member
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove rear extension assembly.
1. Remove parking gear and needle bearing.
  CAUTION: Insert your hand between rear extension and transmission case. Detach rear extension assembly while holding parking gear and needle bearing by hand.
Replace parking components if necessary.
Reinstall any part removed.
- Always use new sealing parts .
  
  Fig 2: Removing Parking Gear & Needle Bearing
  Courtesy of NISSAN MOTOR CO., U.S.A.