FixVault

DTC Confirmation Test

NOTE: Before proceeding, ensure battery voltage is more than 10 volts at idle.
  1. Turn ignition on. Select DATA MONITOR with scan tool.
  2. Check that COOLAN TEMP/S is above 50°F (10°C). If it is above 50°F (10°C), test result is okay. If it is below 50°F (10°C), go to next step.
  3. Start engine and run it for 65 minutes at idle speed.
  4. If COOLAN TEMP/S increases to more than 50°F (10°C) within 65 minutes, stop engine. Test result is okay. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  .