Test Without CONSULT II

It is better to count the time accurately with a clock. It is impossible to switch the diagnostic mode when an accelerator pedal position sensor circuit has a malfunction.

1. Perform Accelerator Pedal Released Position Learning. See ACCELERATOR PEDAL RELEASED POSITION LEARNING  .
2. Perform Throttle Valve Closed Position Learning. See THROTTLE VALVE CLOSED POSITION LEARNING  .
3. Start engine and warm it up to normal operating temperature.
4. Check that all items listed under CONDITIONS  are in good order.
5. Turn ignition switch OFF and wait at least 10 seconds.
6. Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.
7. Repeat the following procedure quickly five times within 5 seconds.
   1. Fully depress the accelerator pedal.
   2. Fully release the accelerator pedal.
8. Wait 7 seconds, fully depress the accelerator pedal and keep it depressed for approximately 20 seconds until the MIL goes off.
9. Fully release the accelerator pedal within 3 seconds after the MIL goes off.
10. Start engine and let it idle.
11. Wait 20 seconds.
12. Rev up the engine two or three times and make sure that idle speed and ignition timing are within the specifications, idle speed MT 575-675 RPM, AT 625-725 RPM, in PARK or NEUTRAL position. Ignition timing MT 10-20° BTDC, AT 10-20° BTDC in PARK or NEUTRAL position.
13. If idle speed and ignition timing are not within the specification, the result will be incomplete. In this case, find the cause of the incident by referring to DIAGNOSTIC PROCEDURE  .