Diagnostic Procedure

With CONSULT-II 

1. Turn ignition switch to "ON" position. (Do not start engine.)
2. Select "SELECTION FROM MENU" in "DATA MONITOR" mode for "A/T" with CONSULT-II and check monitor "STARTER RELAY" (PNP relay) ON/OFF.
   Fig 1: Checking PNP Relay (With CONSULT-II)

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK >> GO TO  4.
2. NG >> GO TO  3.

Without CONSULT-II 

1. Turn ignition switch to "ON" position. (Do not start engine.)
2. Check the voltage between the TCM connector and ground.
   Fig 2: TCM Terminal Connector And Ground Voltage Specifications

   Courtesy of NISSAN MOTOR CO., U.S.A.
   Fig 3: Checking PNP Relay (Without CONSULT-II)

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK >> GO TO  4.
2. NG >> GO TO 3.

Check the following items:

• PNP relay. Refer to "STANDARDIZED RELAY ".
• Disconnections or short-circuits in the harness between TCM and the PNP relay
• Ground circuit for the PNP relay

OK or NG 

1. OK >> GO TO 4.
2. NG >> Repair or replace damaged parts.

Perform "DTC Confirmation Procedure". Refer to "DTC CONFIRMATION PROCEDURE ".

OK or NG 

1. OK >> INSPECTION END 
2. NG >> GO TO 5.

1. Perform TCM input/output signal inspection.
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.

OK or NG 

1. OK >> INSPECTION END 
2. NG >> Repair or replace damaged parts.