FixVault
Home › Infiniti › 2003 › Q45 › Repair and Diagnosis › Transmission › Automatic Trans › Automatic Transaxle › DTC P1764: Direct Clutch Solenoid Valve Function › DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-II 

  1. Start engine.
  2. Accelerate vehicle to maintain the following condition.

    ACCELE POS: 1.5/8 - 2.0/8 

    Selector lever: "D" position 

    Gear position: 1st --> 2nd Gear (D/C ON/OFF) 

  3. Perform step " 2" again.
  4. Turn ignition switch to "OFF" position, then perform step " 1 to  3 " again.
  5. Check "SELF-DIAG RESULTS" mode for "A/T" with CONSULT-II. If DTC (P1764) is detected, refer to "DIAGNOSTIC PROCEDURE ".

    If DTC (P1762) is detected, go to "DIAGNOSTIC PROCEDURE ".

    If DTC (P1845) is detected, go to "DIAGNOSTIC PROCEDURE ".

    Fig 1: Display A/T Engine Sheet With Consult-II
    G02037909Courtesy of NISSAN MOTOR CO., U.S.A.

WITH GST 

Follow the procedure "With CONSULT-II".

About FixVault